If you went this route, you would just tell them that you would want it annealed to a 6063-T5 state. ![]() You can either send it to a shop that does annealing and they will essentially cook your aluminum at a certain temperature until it’s annealed to a specific grade. If you don’t have that option, there are a couple ways around it. So if you’ve got the option, you should just order and use 6063-T5. 6063-T5 is actually more readily available in pipe sizes than tubing sizes. Sure, you can get away with it sometimes as the tempering will vary slightly and you might be able to get away with it being aluminum tubing without it cracking, but I’ve found that to get consistent results you need to use a bendable grade.Īnd that’s what 6063-T5 is – a bendable grade of aluminum tubing. The important thing to know is that it is brittle and will most often crack if you’re trying to bend it with a tight radius. The first thing that you need to be aware of if you’re bending aluminum tubing is that it is commonly available in two different grades – 6061-T-T5.Īnd this is important to know BEFORE you start on your project.Ħ061-T6 aluminum is more of a structural tubing and is often spec’d as a default when it comes to different jobs and designs that you might see. Bending Aluminum Tubing – What You Need to Know BEFORE You Begin
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |